How do they fix to the wall?
See “Wall Fixings” FAQ below.

Can you paint them to a colour-match?
We only offer the finishes shown online, but our natural oak finish peg rails are suitable for staining, waxing or painting over. Your nearest paint store will advise on suitable finishes.

What lengths are available?
Six-pegs are 36″ long, Four-pegs are 22″ long and Two-pegs are 10″ long.

What weight can the Peg Rails carry?
We recommend a maximum of 10kg load per peg (i.e. maximum total 40kg for the SPO4). Please note: it also depends on how well your wall and anchor points perform. The various wall materials combined with different fixings available are too numerous to mention, so please refer to a professional installer if you have any doubts.

How do they fix to the wall?
See “Wall Fixings” FAQ below.

Do they come with towels?
Each holder is available on it’s own, or supplied with one towel where indicated. Spare towels are available separately, and it is useful to have more than one for a fresh supply while laundering.

How do you fit them?
The rope pulls are supplied with a rope, looped at one end. Tie the light cord into this loop and trim to length. Leave enough length to tie into a ferrule if you wish to remove the rope pull. Allow time for the rope to hang straight.

Can I buy re-fills?
Yes. The twine is compostable, so don’t be afraid to use it!

What colour twine is available?
Green, Natural, Russet or Black in the 250g balls and Green or Natural in the 500g balls. Click here to see our balls.

How does the built-in cutter work?
A small steel blade is concealed in a slot on the top of each stand, safe from fingers. Pass the twine over the slot and give it a tug downwards.

Why are they sold in pairs?
We pair them up so you can use them for T-handled tools (spades, forks etc.) It also common for most people to have more than one of something that needs putting in it’s place.

What weight can they carry?
We recommend a maximum of 10kg load per Hang-it Peg. Please note: it also depends on how well your wall and anchor points perform. The various wall materials combined with different fixings available are too numerous to mention, so please refer to a professional installer if you have any doubts

How big are the screws?
The screws protrude 25mm, and have a 5mm diameter thread (Matches a No. 10 rawl plug). We recommend a pilot hole if inserting directly into timber (3mm for softwood or 3.5mm for hardwood).

How do they fix to the wall?
Two keyhole fixings built into the back will slot over screw heads. No screws are supplied – use appropriate screws for the wall you are fixing to.

1. Size No.8 screws (4.0 – 4.5mm thread diameter) will give you the required screw head diameter of 8 – 9mm.
2. Mark out a horizontal line on wall.
3. Hold bottom edge of rail against line (face down) and mark off the centres of the keyhole slots on the line. Please be precise as this is where to position the screws (measure carefully, or use a square to mark centres down to bottom edge of rail using a set square).
4. Drill and insert fixings suitable for the wall type, and allow screw heads to protrude 10mm.
5. Slot rail over the screw heads, adjusting screws ¼ turn until rail is secure.
6. Be careful not to overload the rail.